주요 콘텐츠로 건너뛰기

이 안내서에는 최근 변경 사항이 더 있습니다. 최신 비검증 버전으로 전환하십시오.

iPhone 6 Plus Logic Board Replacement

단지 전제 조건
이 안내서는 다른 가이드의 선행 작업으로 사용하기 위한 것입니다. 그 자체로는 불완전합니다.

필요한 것

  1. iPhone 6 Plus Logic Board Replacement, Logic Board: 1 단계, 이미지 1/1
    • Remove the following screws securing the logic board to the rear case:

    • Two 2.4 mm standoff screws

    • Standoff screws are best removed using an [연계 제품이 누락 또는 비활성화 됨: IF145-343] and driver handle.

    • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

    • One 2.1 mm Phillips #00 screw

  2. iPhone 6 Plus Logic Board Replacement: 2 단계, 이미지 1/1
    • Carefully raise—but do not remove—the logic board, lifting it from the bottom edge nearest the Lightning connector.

  3. iPhone 6 Plus Logic Board Replacement: 3 단계, 이미지 1/1
    • Do not remove the logic board. At this point it is still tethered to the rear case via an antenna connector.

    • Continue carefully lifting the bottom side of the logic board until it is vertical.

  4. iPhone 6 Plus Logic Board Replacement: 4 단계, 이미지 1/2 iPhone 6 Plus Logic Board Replacement: 4 단계, 이미지 2/2
    • Gently lay the logic board upside-down, with the top portion resting against the rear case of the iPhone.

    • Use the flat end of a spudger to disconnect the antenna connector from its socket on the back of the logic board.

  5. iPhone 6 Plus Logic Board Replacement: 5 단계, 이미지 1/1
    • Lift and remove the logic board out of the iPhone.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Walter Galan

693,915 평판

안내서 1,203개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 571