주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

소개

prereq only

  1. Use the flat end of a spudger to disconnect the rear-facing camera connector. Use the flat end of a spudger to disconnect the rear-facing camera connector.
    • Use the flat end of a spudger to disconnect the rear-facing camera connector.

  2. Remove the following Phillips screws securing the rear camera bracket to the rear case: One 1.3 mm screw
    • Remove the following Phillips screws securing the rear camera bracket to the rear case:

    • One 1.3 mm screw

    • One 2.5 mm screw

  3. Remove the bracket.
    • Remove the bracket.

  4. Use the pointed end of a spudger to pry up and disconnect the antenna bus connector, just left of the rear camera module. Use the pointed end of a spudger to pry up and disconnect the antenna bus connector, just left of the rear camera module.
    • Use the pointed end of a spudger to pry up and disconnect the antenna bus connector, just left of the rear camera module.

  5. Remove the two 1.2 mm tri-point screws securing the upper cable bracket.
    • Remove the two 1.2 mm tri-point screws securing the upper cable bracket.

  6. Nintendo Switch Kits

    A quick fix to get back in the game

    Shop Switch Kits

    Nintendo Switch Kits

    A quick fix to get back in the game

    Shop Switch Kits
  7. Remove the upper cable bracket. Remove the upper cable bracket.
    • Remove the upper cable bracket.

  8. Use the flat end of a spudger to disconnect the upper cable connector. Use the flat end of a spudger to disconnect the upper cable connector.
    • Use the flat end of a spudger to disconnect the upper cable connector.

  9. Remove the Phillips screws securing the Wi-Fi antenna: Three 1.2 mm screws
    • Remove the Phillips screws securing the Wi-Fi antenna:

    • Three 1.2 mm screws

    • One 1.7 mm screw

  10. Remove the top left antenna. Remove the top left antenna.
    • Remove the top left antenna.

  11. Remove the following Phillips screws:
    • Remove the following Phillips screws:

    • One 1.3 mm screw

    • One 2.2 mm screw

  12. Remove the bracket. Remove the bracket.
    • Remove the bracket.

  13. Remove the 2.2 mm standoff screw from the grounding bracket.
    • Remove the 2.2 mm standoff screw from the grounding bracket.

    • Standoff screws are best removed using an iPhone Standoff Screwdriver Bit and driver handle.

    • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

  14. Use tweezers to gently bend the logic board grounding bracket out of the way. Use tweezers to gently bend the logic board grounding bracket out of the way.
    • Use tweezers to gently bend the logic board grounding bracket out of the way.

결론

To reassemble your device, follow these instructions in reverse order.

Evan Noronha

회원 가입일: 2015년 02월 05일

183,536 평판

안내서 178개 작성하였습니다

iFixit iFixit 회원

Community

107 회원들

안내서 10,211개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 94