주요 콘텐츠로 건너뛰기

소개

Prerequisite-only guide for removing the speaker. Click here for the full speaker replacement guide.

  1. Use a thin pry tool or tweezers to carefully pry up and disconnect the upper coaxial cable connector from the logic board. There are two coaxial connectors in close proximity. Disconnect the one nearest the battery connector.
    • Use a thin pry tool or tweezers to carefully pry up and disconnect the upper coaxial cable connector from the logic board.

    • There are two coaxial connectors in close proximity. Disconnect the one nearest the battery connector.

    • During reassembly, this can be tricky to reconnect. Hold the connector in place over its socket and press down with the flat of your spudger. The connector should snap into place.

  2. Carefully de-route the coaxial cable you just disconnected from the small metal clip holding it to the logic board. Carefully de-route the coaxial cable you just disconnected from the small metal clip holding it to the logic board.
    • Carefully de-route the coaxial cable you just disconnected from the small metal clip holding it to the logic board.

  3. Use tweezers or the point of your spudger to pry both coaxial cables out of the metal clip holding them on the side of the speaker. Use tweezers or the point of your spudger to pry both coaxial cables out of the metal clip holding them on the side of the speaker.
    • Use tweezers or the point of your spudger to pry both coaxial cables out of the metal clip holding them on the side of the speaker.

  4. Remove the five Phillips screws securing the speaker:
    • Remove the five Phillips screws securing the speaker:

    • Three 1.3 mm screws

    • One 2.3 mm screw

    • One 3.3 mm screw

  5. Remove the speaker.
결론

To reassemble your device, follow these instructions in reverse order.

Jeff Suovanen

회원 가입일: 2013년 08월 06일

243,149 평판

안내서 211개 작성하였습니다

iFixit iFixit 회원

Community

101 회원들

안내서 9,072개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 11