주요 콘텐츠로 건너뛰기

iPod Nano 2nd Generation Bottom Bezel Bracket Replacement

필요한 것

  1. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement, Bottom Bezel: 1 단계, 이미지 1/1
    • Before opening your iPod, ensure that the hold switch is in the locked position.

  2. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 2 단계, 이미지 1/1
    • When removing the the bottom bezel, be sure not to bend the plastic surrounding the dock connector.

    • Carefully insert an iPod opening tool in the seam between the metal casing and white plastic bezel

    • Lift the bottom bezel off the iPod. It's glued on using a mild adhesive, so some force may be required.

  3. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement, Bottom Bezel Bracket: 3 단계, 이미지 1/1
    • Remove the following two screws:

    • One #00 Phillips screw with a large head near the headphone jack.

    • One #00 Phillips screw with a smaller head near the side of the iPod. This screw strips easily, so be sure to press down firmly on the screwdriver.

  4. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 4 단계, 이미지 1/1
    • Use a metal spudger to carefully pry the headphone jack out of the casing. DO NOT remove the headphone jack from the iPod entirely, as it is connected via a fragile ribbon connector to the click wheel.

  5. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 5 단계, 이미지 1/1
    • Slide the headphone jack out until the white plastic housing is no longer held in place by the metal casing.

  6. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 6 단계, 이미지 1/1
    • Remove the newly-revealed Phillips #00 screw from beneath the headphone jack.

  7. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 7 단계, 이미지 1/1
    • Lift the bottom bezel bracket out of the iPod.

결론

To reassemble your device, follow these instructions in reverse order.

다른 7명이 해당 안내서를 완성하였습니다.

iRobot

회원 가입일: 09/24/09

1 평판

안내서 636개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 2

7일 전: 4

30일 전: 25

전체 시간: 17,701