소개

This guide explains how to remove the side brush motor from your Roomba.

부품

부품은 필요하지 않습니다.

  1. Place your Roomba upside-down on a hard surface.
    • Place your Roomba upside-down on a hard surface.

    If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

    David Forrest - 답글

  2. While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
    • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

    댓글 쓰기

    • Gently pull upwards on the brush to remove it.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Rotate the Roomba upside-down so the bottom is facing towards you.

    댓글 쓰기

    • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

    댓글 쓰기

    • Carefully lift the bottom plate.

    • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

    댓글 쓰기

    • Use a Phillips #1 screwdriver to remove the two captive mounting screws on the side wheel motor assembly.

    댓글 쓰기

    • Gently pull on motor assembly to remove.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Aaron Jacobs

회원 가입일: 2014년 01월 31일

525 평판

안내서 4개 작성하였습니다

Cal Poly, Team 13-14, Regan Winter 2014 Cal Poly, Team 13-14, Regan Winter 2014 회원

CPSU-REGAN-W14S13G14

4 회원들

안내서 13개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 2

지난 30일: 7

전체 시간: 700