메뉴

설정

내 작업대

귀하의 기기에 대한 안내서, 부품 및 답변에 신속히 접근할 수 있습니다
내 장바구니

장바구니가 비어 있는 것 같습니다

상점 둘러보기

the Panasonic Lumix DMC-FX01 Camera Lens Replacement

작성자 Caleb Fink (또 다른 기여자 5명)
  • 댓글 0
  • 즐겨찾기 5
  • 완료: 4

난이도

보통

단계

24

소요 시간

45 분 - 1 시간

섹션

5

플래그

1

Confusing Text

헷갈리는 텍스트

해당 안내서의 어떤 텍스트는 헷갈리며, 중복되었거나 주제에서 벗어났습니다. 편집하여 명확하게 하여 주십시오!

소개

The guide takes place from the Camera Lens Assembly guide.

도구

해당 도구 구매

부품

지정된 부품이 없습니다.

  1. Locate the memory card and battery card latch on the bottom of the camera.

    • Locate the memory card and battery card latch on the bottom of the camera.

    • Slide the latch to the open position.

    편집

  2. Open the battery latch, and slide the battery release lever to the right.

    • Open the battery latch, and slide the battery release lever to the right.

    편집

  3. Remove the battery from the camera.

    • Remove the battery from the camera.

    편집

  4. Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

    • Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

    • Use this screwdriver for all screws in the device.

    편집

  5. Remove the 3.15 mm screw on the left side of the camera.

    • Remove the 3.15 mm screw on the left side of the camera.

    편집

  6. Remove the left side casing. Remove the left side casing.

    • Remove the left side casing.

    편집

  7. Remove the two 3.15 mm screws on the right side of the camera.

    • Remove the two 3.15 mm screws on the right side of the camera.

    편집

  8. Remove the bottom right panel.

    • Remove the bottom right panel.

    편집

  9. PC 노트북 배터리

    큰 전력 향상을 위한 손쉬운 수리.

    지금 장보기

    PC 노트북 배터리

    큰 전력 향상을 위한 손쉬운 수리.

    지금 장보기

  10. Gently remove the back casing. Start at the bottom and carefully pry towards the top to get this piece free.

    • Gently remove the back casing.

    • Start at the bottom and carefully pry towards the top to get this piece free.

    편집

  11. Remove the two black 5.35 mm screws that hold in the front faceplate. There may be a third screw the the right of the lens assembly.

    • Remove the two black 5.35 mm screws that hold in the front faceplate.

    • There may be a third screw the the right of the lens assembly.

    편집

  12. Carefully remove the upper assembly, which houses the buttons and the flash battery. Carefully remove the upper assembly, which houses the buttons and the flash battery. Carefully remove the upper assembly, which houses the buttons and the flash battery.

    • Carefully remove the upper assembly, which houses the buttons and the flash battery.

    편집

  13. Carefully remove the front casing after verifying that the thin plastic around the lens is not still attached.

    • Carefully remove the front casing after verifying that the thin plastic around the lens is not still attached.

    편집

  14. Remove the three black 5mm screws attached to the lens frame. Remove the three black 5mm screws attached to the lens frame.

    • Remove the three black 5mm screws attached to the lens frame.

    편집

  15. Remove the lens frame.

    • Remove the lens frame.

    편집

  16. Lift out the circuit board as shown.

    • Lift out the circuit board as shown.

    편집

  17. Lift the two black latches that hold the connector ribbons in place. Disconnect the two ribbons.

    • Lift the two black latches that hold the connector ribbons in place.

    • Disconnect the two ribbons.

    편집

  18. Remove the lens assembly as shown.

    • Remove the lens assembly as shown.

    편집

  19. Remove four 4mm screws from the lens assembly.

    • Remove four 4mm screws from the lens assembly.

    편집

  20. Carefully turn over the assembly. Carefully turn over the assembly.

    • Carefully turn over the assembly.

    편집

  21. Remove the Fixed Frame Unit by separating it from the assembly. Remove the Direct Frame Unit from the assembly.

    • Remove the Fixed Frame Unit by separating it from the assembly.

    • Remove the Direct Frame Unit from the assembly.

    편집

  22. Remove the 1st lens frame from the lens assembly.

    • Remove the 1st lens frame from the lens assembly.

    편집

  23. Detach the 2nd Frame Unit from the assembly.

    • Detach the 2nd Frame Unit from the assembly.

    편집

  24. Remove the 4mm screw from the lens housing.

    • Remove the 4mm screw from the lens housing.

    편집

  25. Separate the lens housing.

    • Separate the lens housing.

    • Replace the lens by gently prying away from the assembly.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 5명과 함께

Caleb Fink

회원 가입일: 2010년 10월 11일

186 평판

안내서 2개 작성하였습니다

배지: 8

배지 +5개 더

팀

Cal Poly, Team 9-22, Regan Fall 2010 Cal Poly, Team 9-22, Regan Fall 2010 회원

CPSU-REGAN-F10S9G22

4 회원들

안내서 8개 작성하였습니다

댓글 0개

의견 추가하세요

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 11,984