주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

3 단계
Pry under the left edge of the home button cable connector to disconnect it from its socket. If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor. If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor.
  • Pry under the left edge of the home button cable connector to disconnect it from its socket.

  • If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor.

Hebele mit einem Plastiköffnungswerkzeug unter der linken Kante des Verbinders am Home Button Kabel, um ihn so zu lösen.

Wenn der Verbinder hoch klappt, ohne sich zu lösen, dann musst du das Kabel an der Oberkante des Verbinders mit dem flachen Ende des Spudgers nach unten drücken und gleichzeitig an der linken Kante des Verbinders nach oben hebeln. Sei dabei äußerst vorsichtig und beschädige weder Kabel noch Verbinder, dadurch kann der Sensor unbrauchbar werden.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.