주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 9개에 영향을 미칩니다.

영어
스페인어

10 단계 번역 중

10 단계
Remove the following screws securing the logic board to the rear case:
  • Remove the following screws securing the logic board to the rear case:

  • Two 2.3 mm Phillips screws

  • Two 2.7 mm standoff screws

  • Standoff screws are best removed using a standoff screwdriver or bit.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

  • One non-magnetic 2.7 mm standoff screw

  • Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass.

Quite los siguientes tornillos que sujetan la placa lógica a la caja trasera:

Estos tornillos tienen un patrón de bits Phillips, pero encontramos la mejor herramienta de extracción para ser un conductor de cabeza plana de 2,5 mm.

Los tornillos separadores se remueven mejor utilizando la punta de destornillador de tornillos separador del iPhone y un mango de destornillador.

Si no hay otra opción, un pequeño destornillador de cabeza plana funcionará—pero ten precaución extra para asegurarte de que no se resbale y dañe los componentes circundantes.

[* black] Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Two 2.7 mm standoff screws
[* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true]a [product|IF145-388-4|standoff screwdriver|new_window=true] or bit.
[* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true]a [product|IF145-388-4|standoff screwdriver|new_window=true] or bit.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* yellow] One non-magnetic 2.7 mm standoff screw
[* icon_note] Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.