주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 9개에 영향을 미칩니다.

영어
프랑스어

10 단계 번역 중

10 단계
Remove the following screws securing the logic board to the rear case:
  • Remove the following screws securing the logic board to the rear case:

  • Two 2.3 mm Phillips screws

  • Two 2.7 mm standoff screws

  • Standoff screws are best removed using a standoff screwdriver or bit.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

  • One non-magnetic 2.7 mm standoff screw

  • Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass.

Retirez les vis suivantes qui fixent la carte mère au boîtier :

deux vis cruciformes 2,3 mm

deux vis d'entretoise 2,7 mm

Le mieux est de dévisser les vis d'entretoise à l'aide d'un embout pour vis d'entretoise et d'un manche du tournevis.

Un petit tournevis plat peut aussi faire l'affaire, mais veillez à ce qu'il ne glisse pas et n'endommage pas les composants qui se trouvent autour.

une vis d'entretoise non magnétisée 2,7 mm

Prenez soin de remettre cette vis dans sa position d'origine sur le dessus de la carte mère. Une vis magnétisée peut interférer avec la boussole numérique.

[* black] Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Two 2.7 mm standoff screws
[* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true]a [product|IF145-388-4|standoff screwdriver|new_window=true] or bit.
[* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true]a [product|IF145-388-4|standoff screwdriver|new_window=true] or bit.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* yellow] One non-magnetic 2.7 mm standoff screw
[* icon_note] Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.