주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 4개에 영향을 미칩니다.

10 단계 번역 중

10 단계
Find a connector on the motherboard labeled HD TMP or HDD TEMP. If you have trouble locating it, trace the two-wire temperature cable you disconnected from the old hard drive. If the previous temperature cable is still connected to the board here, disconnect and remove it.  You will no longer need it.
  • Find a connector on the motherboard labeled HD TMP or HDD TEMP.

  • If you have trouble locating it, trace the two-wire temperature cable you disconnected from the old hard drive.

  • If the previous temperature cable is still connected to the board here, disconnect and remove it. You will no longer need it.

  • Connect the temperature sensor's two-wire red-black cable to the motherboard plug labeled HD TMP or HDD TEMP.

  • The connector is keyed to fit in one way only. If it seems like the connector is not fitting the socket, flip the connector and try again.

  • Route the excess wire so it does not interfere with any other components.

ロジックボードのHD TMPもしくはHDD TEMPに温度センサのケーブルを差し込みます。

場所がわからない場合は、古いHDDドライブから取り外した2線式温度ケーブルをたどります。

以前の温度ケーブルがまだボードに接続されている場合は、取り外します。もう必要ありません。

温度センサーの2線式赤黒ケーブルを、HD TMPまたはHDD TEMPというラベルの付いたマザーボードのプラグに接続します。

コネクタは、一方向にのみ適合するようにツメがあります。 コネクタがソケットに適合していないように見える場合は、コネクタを裏返して再試行してください。

余分なワイヤーを他の部品に干渉しないようにします。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.