주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

1 단계 번역 중

1 단계
Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector in the current orientation so the fans will not run at full speed. If you have multiple pins on your replacement hard drive, put the connector closest to the SATA connections and closest to the PCB board. Disconnect the thermal sensor, SATA power, and SATA data cables by pulling their connectors away from the sockets on the hard drive. Disconnect the thermal sensor, SATA power, and SATA data cables by pulling their connectors away from the sockets on the hard drive.
  • Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector in the current orientation so the fans will not run at full speed. If you have multiple pins on your replacement hard drive, put the connector closest to the SATA connections and closest to the PCB board.

  • Disconnect the thermal sensor, SATA power, and SATA data cables by pulling their connectors away from the sockets on the hard drive.

温度センサーケーブルの接続を外す前に、取り付け位置を記録してください。ファンが最高速で回転しないように、現在の位置にコネクタを再度取り付けることは、極めて重要です。交換用ハードドライブに複数のピンがついていれば、コネクタをSATA接続部とPCBボードに最も近い位置に取り付けます。

ハードドライブのソケットからコネクタを引き抜き、温度センサー、SATA電源、SATAデータケーブルの接続を外します。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.