주요 콘텐츠로 건너뛰기
독일어
영어

Panasonic camera DMC FS 16 CCD cleaning

안내서 정보

= 완료 = 미완료

      작업중인 해당 device의 특정 부분 또는 부품을 설명하여 주십시오. 예: 배터리

      제목을 작성합니다.

      해당 1-2 짧은 문장이 검색 결과에 나타납니다.

      독자가 안내서를 파고들기 전에 배경 정보를 알려주십시오.

      안내서 단계

      1 단계

      Images taken with the FS16 of the same object before and after cleaning.

      2 단계

      Open the battery compartment cover and remove the battery and the memory card,

      3 단계

      Remove the two 4.6 mm # 000 Phillips screws from the bottom near the tripod thread

      4 단계

      Remove the single 3.3 mm # 000 Phillips screw from the right side.

      5 단계

      Remove the four 3.3 mm Phillips screws from the left side

      6 단계

      Use a spudger or plastic opener to remove the rear cover. Start next to the USB cover and slide the tool along the camera. Lift the rear housing cover off.

      7 단계

      Carefully lift the keyboard board vertically upwards with your fingers.

      8 단계

      Under the keyboard board you will find a gray plastic molding. This part is just jammed and with a bit of patience you can remove it with a spudger. Make sure that none of the sensitive detents break off. Start prying at the bottom.

      9 단계

      Under the gray plastic molding you will find the motherboard. You do not have to replace the ribbon cable to the display. It is enough to fold the display away!

      10 단계

      On the opposite side, the display is fixed with a thin piece of sheet metal. Carefully bend the metal away with tweezers or similar tool

      11 단계

      Under the display is another shielding plate. It is attached with two 6.4 mm #000 Phillips screws. Remove those to remove the shield

      12 단계

      The back of the CCD is exposed.

      13 단계

      Flip the CCD up.

      귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.