주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 10개에 영향을 미칩니다.

1 단계 번역 중

1 단계
Completely power off and unplug your MacBook Pro before you begin. Close the display and flip the entire laptop upside-down.
  • Completely power off and unplug your MacBook Pro before you begin. Close the display and flip the entire laptop upside-down.

  • Use a P5 Pentalobe driver to remove six screws securing the lower case, of the following lengths:

  • Four 4.7 mm screws

  • Two 6.6 mm screws

  • Note the orientation of the screws as you remove them—they need to be reinstalled at a slight angle.

  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.

MacBook Proの電源を完全に切って、接続を外します。ディスプレイを閉じて、ラップトップを裏返します。

P5ペンタローブドライバーを使って、次の長さのネジを、下部ケースから外します。

4.7 mmネジー4本

6.6 mmネジー2本

これらのネジを外す際に、ネジの方向を書き留めておきましょう。ある決められた角度でインストールしなければならないネジがあります。

この作業では、各ネジの装着位置を書き留めておきましょう。デバイスのダメージを防ぐため、組み立ての際は、本来の位置に取り付けてください。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.