주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 7개에 영향을 미칩니다.

영어
스페인어
8 단계
The top edge of the display is secured with both glue and clips. Slide the opening pick around the top corner of the display, while gently pulling or wiggling the display down in the direction of the Lightning port. The clips will break if you use too much force. Work carefully and be patient.
  • The top edge of the display is secured with both glue and clips.

  • Slide the opening pick around the top corner of the display, while gently pulling or wiggling the display down in the direction of the Lightning port.

  • The clips will break if you use too much force. Work carefully and be patient.

  • Again, don't insert the pick more than a few millimeters—about the width of the display bezel—or you may damage the front panel sensor array.

  • Slide the pick to the opposite corner and cut any remaining adhesive securing the display.

El borde superior del la pantalla está sujeto con pegamento y clips.

Desliza la púa de apertura alrededor de la esquina de la pantalla, mientras jalas o mueves la pantalla hacia abajo en la dirección del puerto de Lightning.

Los clips se romperán si tu usas demasiado fuerza, Trabaja con cuidado y sé paciente.

Nuevamente, no insertes la púa más de unos pocos milímetros (aproximadamente el ancho del bisel de pantalla) o podrías dañar el conjunto de sensor de panel frontal.

Desliza la púa hacia la esquina opuesta y corta cualquier adhesivo restante que sujeta la pantalla.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.