주요 콘텐츠로 건너뛰기

iPhone XR Pentalobe/펜타로브 나사 교체

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 9 안내서에 영향을 미칩니다.

1 단계 번역중

1 단계
iPhone XR Pentalobe Screws Replacement, Remove the pentalobe screws: 0 단계, 이미지 2개 중 1개 iPhone XR Pentalobe Screws Replacement, Remove the pentalobe screws: 0 단계, 이미지 2개 중 2개
Remove the pentalobe screws
  • Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

  • Power off your iPhone before beginning disassembly.

  • Remove the two 6.7 mm-long pentalobe screws at the bottom edge of the iPhone.

  • Opening the iPhone will compromise its waterproof seals. Have replacement seals ready before you proceed past this step, or take care to avoid liquid exposure if you reassemble your iPhone without replacing the seals.

  • There's a black rubber gasket just beneath the head on each pentalobe screw. For maximum protection against dust and liquid, check the condition of the gaskets or replace the screws during reassembly.

시작하기 전에 iPhone 배터리를 25% 밑으로 방전하십시오. 충전된 리튬-이온 배터리에 실수로 구멍이 생기면 화재를 일으키거나 폭발할 수 있습니다.

분해를 시작하기 전에 iPhone 전원을 꺼주십시오.

iPhone 하단 가장자리에 위치한 6.7mm-길이 pentalobe/펜타로브 나사 두 개를 빼주십시오.

iPhone을 열게되면 방수 봉인이 손상됩니다. 이 단계를 수행하기 전에 교체용 봉인을 준비하거나 봉인 없이 iPhone을 재조립할 경우 액체에 노출되지 않도록 주의하십시오.

각 pentalobe/펜타로브 나사의 머리 바로 밑에는 검정색 고무 개스킷이 있습니다. 먼지와 액체로부터 최대한의 보호를 위하여 재조립할 때 개스킷의 상태를 확인하거나 나사를 교체하십시오.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.