주요 콘텐츠로 건너뛰기

iPhone XR Earpiece and Front Sensor Assembly Replacement/이어피스와 전면 센서 어셈블리 교체

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

8 단계
iPhone XR Earpiece and Front Sensor Assembly Replacement: 0 단계, 이미지 3개 중 1개 iPhone XR Earpiece and Front Sensor Assembly Replacement: 0 단계, 이미지 3개 중 2개 iPhone XR Earpiece and Front Sensor Assembly Replacement: 0 단계, 이미지 3개 중 3개
  • If you successfully removed the entire ambient light sensor, as shown in the first photo, continue to the next step below.

  • If the white diffuser strip is detached and remains embedded in the display, as shown in the second photo, you will need to carefully lever it out along the top edge using a thin blade or pry tool. Re-applying heat first may make this task a bit easier.

  • During reassembly, install the diffuser into the display first, making sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third).

  • Then, set the ambient light sensor on top of the diffuser. You will need to hold the sensor in position while installing the screws securing the earpiece/sensor assembly. Once the screws are tightened, the sensor will stay in place and work normally.

첫 번째 사진과 같이 전체 주변 광 센서를 성공적으로 분리한 경우 다음 단계로 진행하세요.

두 번째 사진과 같이 흰색 디퓨저 스트립이 떨어져서 디스플레이에 박혀 있는 경우 상단 가장자리를 따라 얇은 날 또는 비집어 올리는 도구를 사용하여 조심스럽게 빼내야합니다. 먼저 다시 열을 가하면 이 작업은 더 수월해질 수 있습니다.

재조립할 때 먼저 디퓨저를 디스플레이에 설치하여 올바른 방향을 향하게 하세요 (첫 번째 이미지는 전면, 세 번째에 이미지는 후면).

그 다음 주 광 센서를 디퓨저 위에 올려 놓으세요. 이어피스/센서 어셈블리를 고정하는 나사를 조이는 동안 센서가 제자리에 있어야 합니다. 모든 나사를 조이면 센서는 제 위치에 머물고 정상적으로 작동합니다.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.