주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 8개에 영향을 미칩니다.

1 단계 번역 중

1 단계
Peel up and remove the large rectangular battery board cover, on the edge of the logic board nearest the battery. If the cover doesn't peel up easily, apply mild heat with an iOpener, hair dryer, or heat gun to soften the adhesive underneath, and try again.
  • Peel up and remove the large rectangular battery board cover, on the edge of the logic board nearest the battery.

  • If the cover doesn't peel up easily, apply mild heat with an iOpener, hair dryer, or heat gun to soften the adhesive underneath, and try again.

  • If the cover doesn't seat securely during reassembly, try rotating it 180 degrees. It must be oriented correctly in order for the adhesive pads underneath to contact the board screws.

バッテリー付近のロジックボードの端にある、大きな長方形のバッテリー用ボードカバーを剥がして、取り出します。

カバーが容易に剥がれない場合は、iOpenerやヘアドライヤーもしくはヒートガンを使って接着剤を温めて、この下に留められた接着剤を柔らかくして、再試行してください。

再組み立ての際に、カバーがしっかりと装着しなければ、180度回転させて再施行してください。下の接着パッドがボードのネジに接触するには、正しい方向に装着しなければなりません。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.