주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 13개에 영향을 미칩니다.

11 단계 번역 중

11 단계
Use the point of a spudger to lift the display cable connector up and out of its socket on the motherboard. To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.
  • Use the point of a spudger to lift the display cable connector up and out of its socket on the motherboard.

  • To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

  • If any part of your screen doesn't respond to touch after your repair re-seat this connector, making sure it clicks fully into place and that there's no dust or other obstruction in the socket.

  • During reassembly, pause here and replace the adhesive around the edges of the display.

スパッジャーの先端を使って、ディスプレイケーブルコネクタを跳ね上げて、マザーボード上のソケットから外します。

このように、プレスコネクタの位置を揃えて、カチッと音がするまで、先端を押し込んで再装着します。中央部分を押さえないでください。コネクターの位置がずれている場合は、ピンが曲がってしまい、ダメージにつながります。

このコネクタを再装着した後、スクリーンをタッチしても反応がない場合は、プレスコネクタがしっかりと装着されているか、ソケットに異物がないか、確認してください。

再組み立ての際は、ここで作業を中断して、ディスプレイ周辺の接着剤を交換してください

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.