주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

영어
프랑스어

28 단계 번역 중

28 단계
When reinstalling the logic board assembly: Check the alignment of the rubber vibration dampers, and adjust them as needed. Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.
  • When reinstalling the logic board assembly:

  • Check the alignment of the rubber vibration dampers, and adjust them as needed.

  • Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

  • Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

Au moment de réinstaller la carte mère :

Vérifiez l'alignement des bandes amortissantes en caoutchouc et réajustez au besoin.

Faites passer le faisceau de câbles d'antenne à travers l'espace entre la carte mère et le dissipateur thermique. Assurez-vous qu'il est positionné correctement quand vous réinsérez la carte mère.

Vérifiez aussi qu'aucune nappe ne reste coincée sous la carte. Contrôlez soigneusement chaque zone entourée en orange.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.