주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

28 단계 번역 중

28 단계
When reinstalling the logic board assembly: Check the alignment of the rubber vibration dampers, and adjust them as needed. Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.
  • When reinstalling the logic board assembly:

  • Check the alignment of the rubber vibration dampers, and adjust them as needed.

  • Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

  • Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

ロジックボードアセンブリを再装着する際は:

ゴム製振動バンパーの位置を揃えます。

アンテナケーブルの束をロジックボードとヒートシンクの間の隙間に通します。ボードを所定の位置に装着する時は、正しい方向に並んでいるか確認してください。

ケーブルがボード下に挟まっていないか確認してください。特に3番目の画像のマークされた位置がクリアになっているか点検してください。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.