주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

영어
네덜란드어

28 단계 번역 중

28 단계
When reinstalling the logic board assembly: Check the alignment of the rubber vibration dampers, and adjust them as needed. Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.
  • When reinstalling the logic board assembly:

  • Check the alignment of the rubber vibration dampers, and adjust them as needed.

  • Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

  • Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

Zorg dat je bij het weer installeren van de logic board module:

De positie van de rubberen trildempers checkt en deze op de juiste positie brengt indien nodig.

De antennekabelbundel door het gat tussen het logic board en het koellichaam begeleidt en dat je zorgt dat deze op de juiste positie is aangebracht voordat je het logic board op z'n plek brengt.

Checkt dat er geen kabels onder het logic board vast zijn komen te zitten als je deze installeert. Check de gemarkeerde locaties zorgvuldig.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.