주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 8개에 영향을 미칩니다.

1 단계 번역 중

1 단계
In the following steps you'll be cutting through the adhesive that adheres the rear glass panel to the phone. For reference, the backside of the panel is shown in the first photo. Note the clearance between the edge of the panel and the fragile ribbon cable beside the fingerprint sensor. Be careful as you slice and pry to the left side of the fingerprint sensor, as seen from the outside of the phone in the third photo.
  • In the following steps you'll be cutting through the adhesive that adheres the rear glass panel to the phone.

  • For reference, the backside of the panel is shown in the first photo. Note the clearance between the edge of the panel and the fragile ribbon cable beside the fingerprint sensor.

  • Be careful as you slice and pry to the left side of the fingerprint sensor, as seen from the outside of the phone in the third photo.

  • Inserting an opening tool more than 3 mm into the phone in this area can damage or tear the fingerprint sensor cable.

In den folgenden Schritten wirst du den Kleber auftrennen, mit dem die Glas-Rückabdeckung am Smartphone befestigt ist.

Zur Information ist im ersten Bild die Rückseite der Glasscheibe gezeigt. Beachte den Abstand zwischen der Kante der Glasscheibe und dem empfindlichen Flachbandkabel neben dem Fingerabdrucksensor.

Sei vorsichtig, wenn du an der linken Seite des Fingerabdrucksensors von außen am Smartphone schneidest und hebelst, so wie im dritten Bild gezeigt.

Wenn das Öffnungswerkzeug tiefer als 3 mm an dieser Stelle des Smartphones eingesetzt wird, kann das Kabel zum Fingerabdrucksensor beschädigt oder zerrissen werden.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.