주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

4 단계
Set the drive in the plastic tray and align the drive ports with the tray socket. To prevent strain on the enclosure socket, lay the drive as flat against the tray as possible. Carefully push the drive into the tray socket to seat the ports.
Install the SSD
  • Set the drive in the plastic tray and align the drive ports with the tray socket.

  • To prevent strain on the enclosure socket, lay the drive as flat against the tray as possible.

  • Carefully push the drive into the tray socket to seat the ports.

  • Press the drive's raised edge down into the plastic tray.

  • If the drive edge catches on the foam block, the drive is not fully seated against the tray socket. Continue pressing the drive into the socket until it clears the foam block.

Setze die SSD in den Kunststoffeinschub ein und richte die Anschlüsse des Laufwerks am Sockel des Einschubs aus.

Lege das Laufwerk so flach wie möglich in den Einschub ein, damit die Kontakte des Sockels nicht zu stark belastet werden.

Drücke das Laufwerk behutsam in den Sockel hinein.

Drücke die hochstehende Kante des Laufwerks in den Kunststoffeinschub hinein.

Wenn die Kante des Laufwerks im Schaumstoffblock hängen bleibt, dann sitzt der Anschluss des Laufwerks nicht richtig im Sockel des Einschubs drin. Drücke das Laufwerk tiefer in den Sockel hinein, bis die Kante vom Schaumstoff frei kommt.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.