주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 4개에 영향을 미칩니다.

20 단계 번역 중

20 단계
At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips. If you've already verified that your iMac is working correctly and are ready to seal it up, skip to step 22. Gently insert the display data connector into its socket on the logic board. Be sure to press it straight into the socket, and insert it completely.
Test your repair
  • At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.

  • If you've already verified that your iMac is working correctly and are ready to seal it up, skip to step 22.

  • Gently insert the display data connector into its socket on the logic board. Be sure to press it straight into the socket, and insert it completely.

  • Flip the display data connector lock down onto the socket.

  • Insert the display power connector into its socket on the logic board.

この時点で、修理の状況をテストして、iMacが正しく起動することを確認してから再組み立てすることをお勧めします。 接着ストリップの裏地を剥がす前に、次の3つの手順に従って、ディスプレイケーブルを一時的に再接続し、iMacを起動します。

iMacが正しく動作していることを確認し、密封する準備ができている場合は、手順22に進んでください。

ディスプレイデータコネクタをロジックボードのソケットに挿入します。 ソケットに真っ直ぐ押し込み、しっかり奥まで差し込みます。

ディスプレイデータコネクタのロックをソケット上に下ろします。

ディスプレイの電源コネクタをロジックボードのソケットに挿入します。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.