주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 4개에 영향을 미칩니다.

영어
프랑스어

14 단계 번역 중

14 단계
The microphone hole is the center hole flanked by two larger holes. Align the adhesive strip to the bottom edge by positioning the microphone notch over the microphone hole. If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend sits next to the right vertical adhesive. The L-bend should not overlap the right vertical adhesive.
  • The microphone hole is the center hole flanked by two larger holes.

  • Align the adhesive strip to the bottom edge by positioning the microphone notch over the microphone hole.

  • If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend sits next to the right vertical adhesive. The L-bend should not overlap the right vertical adhesive.

  • The adhesive tears easily. Be careful not to pull on the strip with too much force.

  • Once you have aligned the strip, carefully set the left exposed edge onto the iMac to secure the alignment.

Le trou du microphone est le trou central flanqué de deux trous plus grands.

Alignez la bande adhésive sur le bord inférieur en positionnant l'encoche du microphone sur le trou du microphone.

Si votre iMac n'a pas de trou pour microphone, alignez l'extrémité droite de la bande de sorte que le coude en L se trouve à côté de l'adhésif vertical droit. Le coude en L ne doit pas chevaucher l'adhésif vertical droit.

L'adhésif se déchire facilement. Attention à ne pas tirer trop fort sur la bande.

Une fois la bande alignée, contrôlez soigneusement le bord gauche exposé sur l'iMac pour sécuriser l'alignement.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.