주요 콘텐츠로 건너뛰기

Samsung Galaxy Note20 drahtlose Ladespule ersetzen

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 11개에 영향을 미칩니다.

3 단계
Samsung Galaxy Note20 Wireless Charging Coil Replacement, Disconnect the battery: 0 단계, 이미지 2개 중 1개 Samsung Galaxy Note20 Wireless Charging Coil Replacement, Disconnect the battery: 0 단계, 이미지 2개 중 2개
Disconnect the battery
  • While using a pair of tweezers to hold the motherboard shield out of the way, use the pointed end of a spudger to pry up the battery press connector.

  • Take care to pry only under the edge of the connector to prevent damaging the socket itself and surrounding components.

  • To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

Halte die Abschirmung der Hauptplatine mit einer Pinzette aus dem Weg und heble gleichzeitig den Druckstecker des Akkus mit der Spudgerspitze hoch.

Achte darauf, dass du nur an der Kante des Steckers hebelst, damit der Anschluss und umliegende Bauteile nicht beschädigt werden.

Um Druckstecker, wie diesen hier, wieder anzuschließen, musst du ihn sorgfältig ausrichten und dann auf einer Seite herunterdrücken, bis er einrastet. Wiederhole dann für die andere Seite. Drücke nicht in der Mitte, wenn der Stecker schief sitzt könnten die Kontaktstifte verbogen und irreparabel beschädigt werden.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.