물건을 수리하세요 커뮤니티 상점

Desmontaje del mando (controlador) inalámbrico de la Xbox One Elite Series 2

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

안내서로 돌아가기
영어
스페인어
6 단계
Xbox One Elite Wireless Controller Series 2 Disassembly, Removing the Vibration Motors And Screws From the Motherboard: 0 단계, 이미지 2개 중 1개 Xbox One Elite Wireless Controller Series 2 Disassembly, Removing the Vibration Motors And Screws From the Motherboard: 0 단계, 이미지 2개 중 2개
Removing the Vibration Motors And Screws From the Motherboard

  • The wires will need to be desoldered from the board, and will be replaced later for reassembly.

  • Note: each pair of wires has the black cable soldered to the lower connection; keep this in mind for the reassembly if the pictures from this guide aren't nearby.

  • Note: You may be able to get away without desoldering these, depending on what you need to reach (credit to @bikemerlin), but due to the simplicity and fragility of these connections, I would suggest removing them to prevent additional damage.

  • Some of the solder in this controller requires a very high temperature to release. I had mine set to 450 C, however you may be able to remove it at a lower temperature.

  • Remove the two T-6 screws from the board near the vibration motors.

Extraer los motores de vibración y los tornillos de la placa base

Será necesario desoldar los cables de la placa y se reemplazarán más tarde para volver a ensamblarlos.

Nota: cada par de hilos tiene el cable negro soldado a la conexión inferior; ten esto en cuenta para el montaje si no tienes cerca las imágenes de esta guía.

Nota: Es posible que pueda escaparte y no tener que desoldar estos, dependiendo de lo que necesites alcanzar (crédito para @bikemerlin), pero debido a la simplicidad y fragilidad de estas conexiones, sugeriría quitarlas para evitar daños adicionales.

Parte de la soldadura en este controlador requiere una temperatura muy alta para liberarse. Yo tenía el mío configurado a 450 C, sin embargo, es posible que puedas eliminarlo a una temperatura más baja.

Retira los dos tornillos T-6 de la placa cerca de los motores de vibración.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.