물건을 수리하세요 커뮤니티 상점

Retrait patins de souris (cache-vis) Logitech MX Master 3 pour Mac

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 11개에 영향을 미칩니다.

안내서로 돌아가기
영어
프랑스어
2 단계
Logitech MX Master 3 for Mac Mouse Feet (That Cover Screws) Removal, Separate the mouse foot adhesive: 0 단계, 이미지 3개 중 1개 Logitech MX Master 3 for Mac Mouse Feet (That Cover Screws) Removal, Separate the mouse foot adhesive: 0 단계, 이미지 3개 중 2개 Logitech MX Master 3 for Mac Mouse Feet (That Cover Screws) Removal, Separate the mouse foot adhesive: 0 단계, 이미지 3개 중 3개
Separate the mouse foot adhesive

  • Slide an opening pick under an edge of the left mouse foot.

  • Go slowly, and make sure the pick slides underneath both the foot and its adhesive pad. These layers separate easily.

  • If you plan on reusing your mouse feet, be careful not to crease them or separate them from their adhesive pads.

  • If the foot feels stuck, apply more heat before continuing.

  • Slide your pick under the foot to separate its adhesive until you can grab it with your fingers.

  • Peel up and remove the left mouse foot.

Séparer l'adhésif des patins de la souris

Insérez un médiator entre le patin gauche de la souris et le boîtier.

Travaillez avec précaution. Assurez-vous que le médiator se trouve sous le patin et la couche adhésive. Il est facile de séparer ces deux couches.

Si vous prévoyez de réutiliser les patins de votre souris, veillez à ne pas les froisser ni à les séparer de leurs coussinets adhésifs.

Si le patin reste coincé, refaites-le chauffer avant de continuer.

Faites glisser votre médiator sous le patin pour décoller son adhésif, jusqu'à pouvoir le saisir avec vos doigts.

Décollez et retirez le patin de souris gauche.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.