주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 3개에 영향을 미칩니다.

7 단계 번역 중

7 단계
When reassembling your device, be sure the heat sink's rubber gasket is installed correctly. The nub on the gasket should mate with the hole cut into the logic board near the heat sink fins. The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board. Make sure the antenna cables are inserted into their respective notches on the logic board, as highlighted in the last picture.
  • When reassembling your device, be sure the heat sink's rubber gasket is installed correctly. The nub on the gasket should mate with the hole cut into the logic board near the heat sink fins.

  • The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board.

  • Make sure the antenna cables are inserted into their respective notches on the logic board, as highlighted in the last picture.

デバイスを再組み立てする際は、ヒートシンクのゴム製ガスケットが正しく装着されているか確認してください。ガスケットの突起はヒートシンクのフィン付近のロジックボードの切り欠きと合わさります。

ガスケットの先端がヒートシンクの突起に合わさり、ロジックボード上にあるヒートシンクタブの下に装着しません。

アンテナケーブルをロジックボード上の各切り欠きに挿入しているか確認してください。最後の画像で確認できます。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.