주요 콘텐츠로 건너뛰기

Fix Your Stuff

Right to Repair

Parts & Tools

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

2 단계
Disconnect the camera cable connector with the tip of a spudger. Push first on one side of the connector, then on the other side to carefully "walk" it out of its socket.
  • Disconnect the camera cable connector with the tip of a spudger.

  • Push first on one side of the connector, then on the other side to carefully "walk" it out of its socket.

  • Pull the camera cable parallel to the face of the I/O board toward the front edge of the Air to disconnect it from its socket.

  • Do not lift upward on this cable as you disconnect it, as its socket may break off the logic board.

Trenne den Kamerakabelstecker mit der Spudgerspitze.

Drücke zuerst auf eine Seite des Steckers, dann auf die andere Seite, um ihn vorsichtig aus seiner Fassung "herauszuruckeln".

Ziehe das Kamerakabel parallel zu der Vorderseite der I/O Blende in Richtung der Vorderkante des Airs, um es aus seiner Fassung zu trennen.

Ziehe dieses Kabel nicht nach oben wenn es trennst, da die Fassung aus dem Logic Board brechen kann.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.