메인 콘텐츠로 스킵하기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 2 안내서에 영향을 미칩니다.

2 단계 번역 중

2 단계
If the heat sink seems to be stuck to the logic board after removing all four screws, use a spudger to carefully separate the heat sink from the face of the CPU. Remove the heat sink from the logic board.
  • If the heat sink seems to be stuck to the logic board after removing all four screws, use a spudger to carefully separate the heat sink from the face of the CPU.

  • Remove the heat sink from the logic board.

  • When reinstalling the heat sink, be sure to apply a new layer of thermal paste. If you have never applied thermal paste before, we have a guide that makes it easy.

Wenn der Kühlkörper noch am Logic Board festzuhängen scheint, obwohl alle vier Schrauben entfernt wurden, dann kannst du ihn mit einem Spudger vorsichtig von den Kontaktflächen zur CPU ablösen.

Entferne den Kühlkörper vom Logic Board.

Bringe beim Zusammenbau eine neue Schicht von Wärmeleitpaste auf. Wenn du das noch nie durchgeführt hast, hilft dir unsere Anleitung dabei.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.