주요 콘텐츠로 건너뛰기

Logitech G Pro X Superlight Scrollrad-Platine tauschen

4 단계
Logitech G Pro X Superlight Scroll Wheel Board Replacement: 0 단계, 이미지 3개 중 1개 Logitech G Pro X Superlight Scroll Wheel Board Replacement: 0 단계, 이미지 3개 중 2개 Logitech G Pro X Superlight Scroll Wheel Board Replacement: 0 단계, 이미지 3개 중 3개
  • A small spring holds the right side of the scroll wheel in place. Be careful during this step, as the spring will eject with very little force.

  • Use tweezers to lift the longer edge of the spring out of its groove and remove the spring.

  • Installing the spring during reassembly is very tricky and will most likely take multiple attempts—be patient and work slowly. To install the spring, perform the following:

  • Place the circular part of the spring onto its post so the longer end is closer to the scroll wheel mounting peg.

  • Guide the short end of the spring into its slot near the rear of the scroll wheel.

  • Lift the long end of the spring over and into its groove, so it's sitting on top of the scroll wheel mounting peg.

Eine kleine Feder hält die rechte Seite des Scrollrads in Position. Sei bei diesem Schritt vorsichtig, da die Feder schon bei sehr geringer Kraft herausspringt.

Verwende eine Pinzette, um die längere Kante der Feder aus ihrer Rille zu heben und die Feder zu entfernen.

Das Einsetzen der Feder beim Wiederzusammenbau ist sehr knifflig und erfordert höchstwahrscheinlich mehrere Versuche – sei geduldig und arbeite langsam. Um die Feder einzusetzen, gehe wie folgt vor:

Setze den runden Teil der Feder auf den Stift, sodass das längere Ende näher am Befestigungsstift des Scrollrads liegt.

Führe das kurze Ende der Feder in seinen Schlitz nahe der Rückseite des Scrollrads ein.

Hebe das lange Ende der Feder über die Rille und in diese hinein, sodass sie auf dem Befestigungsstift des Scrollrads sitzt.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.