주요 콘텐츠로 건너뛰기

Logitech G Pro X Superlight Scroll Wheel Board Replacement

4 단계
Logitech G Pro X Superlight Scroll Wheel Board Replacement: 0 단계, 이미지 3개 중 1개 Logitech G Pro X Superlight Scroll Wheel Board Replacement: 0 단계, 이미지 3개 중 2개 Logitech G Pro X Superlight Scroll Wheel Board Replacement: 0 단계, 이미지 3개 중 3개
  • A small spring holds the right side of the scroll wheel in place. Be careful during this step, as the spring will eject with very little force.

  • Use tweezers to lift the longer edge of the spring out of its groove and remove the spring.

  • Installing the spring during reassembly is very tricky and will most likely take multiple attempts—be patient and work slowly. To install the spring, perform the following:

  • Place the circular part of the spring onto its post so the longer end is closer to the scroll wheel mounting peg.

  • Guide the short end of the spring into its slot near the rear of the scroll wheel.

  • Lift the long end of the spring over and into its groove, so it's sitting on top of the scroll wheel mounting peg.

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.