DualSense Edge Rear Case Replacement

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 14 안내서에 영향을 미칩니다.

안내서로 돌아가기

영어

한국어

10 단계 번역중

10 단계

DualSense Edge Rear Case Replacement, Replace the slider covers: 0 단계, 이미지 3개 중 1개

DualSense Edge Rear Case Replacement, Replace the slider covers: 0 단계, 이미지 3개 중 2개

DualSense Edge Rear Case Replacement, Replace the slider covers: 0 단계, 이미지 3개 중 3개

Replace the slider covers

The rear case holds two small plastic covers for the adaptive trigger assembly adjustment sliders. These may have come off during removal. Place them back in the rear cover now to avoid losing them.
Use a pair of tweezers or your fingers to lift the cover from the controller.
Slide the flat end of the cover under the plastic tab in the rear case.
Make sure it is placed so it can move freely in its groove. The edge with the notch should be towards the middle of the controller.
If a cover got bent during the rear case removal or reassembly process, apply a small amount of heat with a hair dryer to restore it to its original shape.
During reassembly, you can use a small piece of painter's tape on the outside of the rear case to hold the covers in place.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.