주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

영어
스페인어

11 단계 번역 중

11 단계
Proceed to solder the black cable from the AC charger to the outer wire of your Macbook connector. Isolate that wire. You don't need to cover up the whole extension of the outer wire, just enough so that it won't touch the white cable or the circuit board of the AC adapter. You can use the black rubber tube or  electrical tape. If you use the black tube try to keep it as far away as possible when soldering to prevent it from shrinking before you cover the wire.
  • Proceed to solder the black cable from the AC charger to the outer wire of your Macbook connector.

  • Isolate that wire. You don't need to cover up the whole extension of the outer wire, just enough so that it won't touch the white cable or the circuit board of the AC adapter.

  • You can use the black rubber tube or electrical tape. If you use the black tube try to keep it as far away as possible when soldering to prevent it from shrinking before you cover the wire.

Continúa soldando el cable negro del cargador con el cable externo del conector de tu MacBook.

Aísla el cable. No es necesario que cubras toda la superficie del cable exterior, sólo lo suficiente para que no toque el cable blanco o la placa de circuito del cargador.

Puedes usar el tubo termorretráctil o cinta aislante. Si usas el tubo termorretráctil trata de mantenerlo lo más alejado que puedas cuando vayas a soldar para evitar que se encoja antes de que cubras el cable.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.