주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

2 단계
Use the tip of a spudger to pry the ringer switch bracket away from the side of the case. Remove the ringer switch from its recess between the ringer switch bracket and the case. Note the orientation for reassembly: The red line should be at the top of the button. The notch in the back of the ringer switch button should be in the same position as, and mate with, the mechanical switch on the cable.
  • Use the tip of a spudger to pry the ringer switch bracket away from the side of the case.

  • Remove the ringer switch from its recess between the ringer switch bracket and the case.

  • Note the orientation for reassembly: The red line should be at the top of the button. The notch in the back of the ringer switch button should be in the same position as, and mate with, the mechanical switch on the cable.

Heble mit der Spitze eines Spudgers die Halterung des Rufton-Schalters von der Seite des Gehäuses weg.

Entferne den Rufton-Schalter aus seiner Vertiefung zwischen der Halterung und dem Gehäuse.

Merke dir die Ausrichtung für den Wiederzusammenbau: Die rote Linie sollte oben an der Taste sein. Die Kerbe hinten auf dem Rufton-Schalter sollte in der gleichen Position sein, wie der mechanische Schalter am Kabel.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.