주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

영어
스페인어
2 단계
Before removing the hoses, the brake fluid on that caliper should be allowed to drain. This is done through the bleed screw on each caliper. The following bleed screws are shown: Front caliper bleed screw
  • Before removing the hoses, the brake fluid on that caliper should be allowed to drain.

  • This is done through the bleed screw on each caliper. The following bleed screws are shown:

  • Front caliper bleed screw

  • Rear caliper bleed screw

  • Allow the fluid to drain by loosening the screw just two or three turns until the fluid is dripping quickly. Use a 9mm box end wrench for this job.

Antes de quitar las mangueras, se debe permitir que drene el líquido de frenos en esa pinza.

Esto se hace a través del tornillo de purga en cada calibre. Se muestran los siguientes tornillos de purga:

Tornillo de purga de la pinza delantera

Tornillo de purga de la pinza trasera

Permita que el fluido se drene aflojando el tornillo solo dos o tres vueltas hasta que el fluido se drene rápidamente. Use una llave de extremo de caja de 9 mm para este trabajo.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.