주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 71개에 영향을 미칩니다.

영어
스페인어

25 단계 번역 중

25 단계
Be very careful with this step. Take your time and ensure the adhesive is hot and soft, and that you've been through all of the adhesive with an opening pick. Don't be afraid to stop and reheat. On the side of the iPad opposite the volume controls, you should have a pick lodged into each corner. Twist the picks to lift the glass slightly, separating the last of the adhesive along the display cable edge.
  • Be very careful with this step. Take your time and ensure the adhesive is hot and soft, and that you've been through all of the adhesive with an opening pick. Don't be afraid to stop and reheat.

  • On the side of the iPad opposite the volume controls, you should have a pick lodged into each corner. Twist the picks to lift the glass slightly, separating the last of the adhesive along the display cable edge.

  • If you encounter a significant amount of resistance, leave the picks in place, reheat, and reapply the iOpener to the problem areas.

Ten mucho cuidado con este paso. Tómate tu tiempo y asegúrate de que el adhesivo esté caliente y suave, y que haya pasado por todo el adhesivo con una púa de apertura. No tengas miedo de detenerte y recalentar.

En el lado del iPad opuesto a los controles de volumen, debe tener una púa alojada en cada esquina. Gira las púas para levantar ligeramente el vidrio, separando el último adhesivo a lo largo del borde del cable de la pantalla.

Si encuentras una cantidad significativa de resistencia, deja las púas en su lugar, vuelve a calentar y vuelve a aplicar el iOpener en las áreas problemáticas.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.