주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

6 단계
Use a spudger to pry the hard drive away from the interface board. Wedge the flat end of the spudger between the interface board and the far right side of hard drive and wiggle back and forth until the hard drive slides out about a sixteenth of an inch. Then move to the other side and repeat the procedure. Go back and forth until the hard drive slides free.
  • Use a spudger to pry the hard drive away from the interface board. Wedge the flat end of the spudger between the interface board and the far right side of hard drive and wiggle back and forth until the hard drive slides out about a sixteenth of an inch. Then move to the other side and repeat the procedure. Go back and forth until the hard drive slides free.

  • When reinstalling the hard drive, make sure that you don't slide the top pins into the lower row of holes.

Heble die Festplatte mit dem Spudger von der Interface-Platine weg. Klemme die Klinge des Spudgers zwischen die Anschlussplatine und der ganz rechts liegenden Seite der Festplatte hinein. Wackle dann etwas vor und zurück, bis sie etwa 2 mm herausgekommen ist. Wiederhole dann das Ganze an der anderen Seite. Gehe hin und her, bis sie draußen ist.

Achte beim Zusammenbau darauf, dass die oberen Stifte nicht in untere Lochreihe hineingreifen.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.