주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 6개에 영향을 미칩니다.

9 단계
Repeat this procedure with the adjacent battery cell: Apply a small amount of liquid adhesive remover under the battery cell, and wait 2-3 minutes for it to penetrate and soften the adhesive. Alternatively, re-heat this section with your iOpener if needed.
  • Repeat this procedure with the adjacent battery cell:

  • Apply a small amount of liquid adhesive remover under the battery cell, and wait 2-3 minutes for it to penetrate and soften the adhesive.

  • Alternatively, re-heat this section with your iOpener if needed.

  • Push a plastic card about an inch between the battery cell and the upper case, and slowly pry the cell up to separate all of the adhesive.

Wiederhole die obigen Schritte mit der benachbarten Akkuzelle:

Gib eine kleine Menge des flüssigen Klebstoffentferners unter die Akkuzelle und warte 2-3 Minuten, damit er einziehen und den Kleber auflösen kann.

Wenn du mit der alternativen Methode arbeitest, erhitze bei Bedarf den Bereich erneut mit dem iOpener.

Schiebe eine Plastikkarte etwa zweieinhalb Zentimeter zwischen den Akku und das obere Gehäuse. Dann heble die Zelle langsam nach oben, damit der ganze Kleber sich löst.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.