주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 80개에 영향을 미칩니다.

3 단계
Use the tool like a pizza cutter—roll it along through the gap, and it will cut the foam adhesive through the center. Be sure to always push with the handle behind the cutting wheel. If you pull, the wheel might get pulled out of the handle. Run the tool up along the left side of the display.
  • Use the tool like a pizza cutter—roll it along through the gap, and it will cut the foam adhesive through the center.

  • Be sure to always push with the handle behind the cutting wheel. If you pull, the wheel might get pulled out of the handle.

  • Run the tool up along the left side of the display.

Benutze es wie einen Pizzaschneider - Rolle es entlang des Spalts und trenne dabei den Klebeschaum in der Mitte.

Achte darauf, dass du es immer mit dem Handgriff hinter dem Schneidrad führst. Wenn du ziehst, kann sich das Rad aus dem Griff lösen.

Lasse das Werkzeug die linke Seite des Displays entlang laufen.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.