주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 80개에 영향을 미칩니다.

영어
스페인어

18 단계 번역 중

18 단계
With both plastic cards inserted as shown near the corners, gently twist the cards sideways to increase the gap between display and case. If there are any sections that seem to stick and won't separate, stop twisting and use one of the cards to cut the remaining adhesive. Begin to lift the top of the display up from the frame.
  • With both plastic cards inserted as shown near the corners, gently twist the cards sideways to increase the gap between display and case.

  • If there are any sections that seem to stick and won't separate, stop twisting and use one of the cards to cut the remaining adhesive.

  • Begin to lift the top of the display up from the frame.

  • Only lift the display a few inches—the display data and power cables are still connected to the logic board.

Con ambas tarjetas de plástico insertadas como se muestra cerca de las esquinas, gire suavemente las tarjetas hacia los lados para aumentar el espacio entre la pantalla y la carcasa.

Si hay secciones que parecen adherirse y no se separan, deje de girar y use una de las tarjetas para cortar el adhesivo restante.

Comience a levantar la parte superior de la pantalla desde el marco.

Solo levante la pantalla unas pulgadas: los datos de la pantalla y los cables de alimentación todavía están conectados a la placa lógica.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.