주요 콘텐츠로 건너뛰기
영어
이탈리아어
8 단계
The touch grid is made up of two distinct circuit boards, joined by a small ribbon cable. One is lined with LEDs and projects, from the top and left side of the Kindle's display. and the other is made up of IR receivers (likely phototransistors), and makes up the right and bottom edges of the display. We pulled out our favorite home-hacked IR camera to see this in action.
  • The touch grid is made up of two distinct circuit boards, joined by a small ribbon cable.

  • One is lined with LEDs and projects, from the top and left side of the Kindle's display. and the other is made up of IR receivers (likely phototransistors), and makes up the right and bottom edges of the display.

  • We pulled out our favorite home-hacked IR camera to see this in action.

  • There's a bit of circuitry on the receiver board, to monitor the breaks in projected light and detect touch:

  • Neonode zForce NN1001 Single Chip Optical Touch Controller

  • Texas Instruments MSP430G2 Ultra Low Power Microcontroller

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.