Skip to main content

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 19 안내서에 영향을 미칩니다.

4 단계 번역 중

4 단계
Tilt the battery away from the logic board enough to access the battery cable connector.
  • Tilt the battery away from the logic board enough to access the battery cable connector.

  • Pull the battery cable connector away from its socket on the logic board and remove the battery from the upper case.

  • Pull the battery cable connector away from the center of the logic board.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Next, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.

将电池从逻辑板上倾斜到足以触碰电池电路。

将电池电路从逻辑板上的插座中拔出,然后从上盖取出电池。

将电池电路拉离逻辑板的中心。

如果你在安装新电池,你应该在安装完成后进行校准

把电池充满,然后至少继续充电两个小时。之后,像往常一样使用它,消耗电量。当你看到低电量警告时,保存好你的工作,然后让笔记本开着,直到它因为低电量而入睡。再等待至少五个小时,之后再把你的笔记本充满到100%

如果在安装新电池后你发现了一些异常状况或麻烦,你可能需要重置你的Macbook的设备管理器

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.