주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 7개에 영향을 미칩니다.

1 단계 번역 중

1 단계
Use the flat end of a spudger to lift the right fan connector out of its socket on the logic board. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.
  • Use the flat end of a spudger to lift the right fan connector out of its socket on the logic board.

  • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

  • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

スパッジャーの平面側先端を使って、ロジックボード上のソケットから右側ファンのコネクタを持ち上げます。

コネクタを外すには、ファンケーブルのワイヤの下から、スパッジャーを垂直に捻ると作業がしやすいです。

ファンのソケットとファンのコネクタは2番目と3番目の画像で確認できます。スパッジャーを使って、ファンコネクタを持ち上げてソケットから外します。プラスチック製ファンのソケットをロジックボードから外す際には、これを壊さないようにご注意ください。2番目の画像のロジックボードのレイアウトは、お持ちのモデルと比べると若干異なるかもしれません。しかし、ファンのソケットは同一です。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.