주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

31 단계 번역 중

31 단계
The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself. Carefully insert an opening pick under the ribbon cable near the Lighting connector housing.
  • The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself.

  • Carefully insert an opening pick under the ribbon cable near the Lighting connector housing.

  • Slide the opening pick toward the logic board, but stop half an inch from the bend in the cable.

  • Continuing farther along the ribbon cable risks cutting it.

Das Lightning Connector Kabel ist am Gehäuse festgeklebt. Um das Kabel abzulösen, musst du ein Plektrum zwischen Kabel und Gehäuse schieben. Achte darauf, dass du dabei nicht das Kabel selbst durchtrennst.

Setze vorsichtig ein Plektrum unter das Flachbandkabel nahe der Fassung des Lightning Connectors.

Schiebe das Plektrum in Richtung Logic Board, halte aber etwa 1,3 cm vor der Biegung im Kabel an.

Wenn du das Plektrum weiter schiebst, riskierst du eine Beschädigung des Kabels.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.