주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

31 단계 번역 중

31 단계
The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself. Carefully insert an opening pick under the ribbon cable near the Lighting connector housing.
  • The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself.

  • Carefully insert an opening pick under the ribbon cable near the Lighting connector housing.

  • Slide the opening pick toward the logic board, but stop half an inch from the bend in the cable.

  • Continuing farther along the ribbon cable risks cutting it.

Lightningコネクタケーブルは、接着剤でケースに貼り付けられています。 接着剤を剥がすには、ケーブルとケースの間に開口ピックを差し込んでスライドします。 Lightningコネクタケーブル自体を切断しないように十分注意してください。

開口ピックをLightingコネクタのハウジング付近のリボンケーブル下に差し込みます。

開口ピックをロジックボード側に向けてスライドしますが、ケーブルが曲がっている箇所の手前1cmあたりで止めます。

さらにスライドするとリボンケーブルを切断してしまう可能性があるからです。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.