주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

32 단계 번역 중

32 단계
Reinsert the opening pick under the Lightning connector ribbon cable from the case-side edge. Slide the pick along the Lightning connector ribbon cable and under the logic board. Move slowly and carefully. If the opening pick does not slide easily, apply more heat and try again. If you use excessive force, you will likely slip and sever the Lightning connector cable.
  • Reinsert the opening pick under the Lightning connector ribbon cable from the case-side edge.

  • Slide the pick along the Lightning connector ribbon cable and under the logic board.

  • Move slowly and carefully. If the opening pick does not slide easily, apply more heat and try again. If you use excessive force, you will likely slip and sever the Lightning connector cable.

Setze das Plektrum wieder unter das Flachbandkabel zum Lightning Connector ein, diesmal an der Kante nahe der Gehäuseseite.

Schiebe das Plektrum am Lightning Connector Kabel entlang und unter das Logic Board.

Arbeite langsam und sorgfältig. Wenn es schwergängig wird, dann erwärme den Bereich erneut und versuche es noch einmal. Wenn du zu stark drückst, kannst du abrutschen und das Flachbandkabel zum Lightning Connector beschädigen.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.