주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

46 단계 번역 중

46 단계
Lift the logic board by the camera end and gently pull the Lightning connector housing out of the rear case. Remove the logic board from the iPad. If there is any resistance from the Lighting port cable stop pulling to avoid ripping the cable. Slide the opening pick under the length of the cable again to fully free it from the rear case.
  • Lift the logic board by the camera end and gently pull the Lightning connector housing out of the rear case.

  • Remove the logic board from the iPad.

  • If there is any resistance from the Lighting port cable stop pulling to avoid ripping the cable. Slide the opening pick under the length of the cable again to fully free it from the rear case.

Hebe das Logic Board am Ende mit der Kamera an und ziehe vorsichtig die Fassung des Lightning Connectors aus dem Rückgehäuse heraus.

Entferne das Logic Board vom iPad.

Wenn du einen Widerstand vom Kabel des Lightning Ports spürst, dann ziehe nicht weiter, sonst könnte das Kabel reißen. Schiebe das Plektrum nochmals unter das Kabel und trenne alle restlichen Klebeverbindungen zum Rückgehäuse auf.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.