주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 3개에 영향을 미칩니다.

11 단계 번역 중

11 단계
Use a spudger to disconnect the headphone jack cable from the logic board. You need to gently pry the connector toward (or up, if you like, the connector is like LEGO® building blocks) the front of the iPod until it comes loose from the logic board.
  • Use a spudger to disconnect the headphone jack cable from the logic board. You need to gently pry the connector toward (or up, if you like, the connector is like LEGO® building blocks) the front of the iPod until it comes loose from the logic board.

  • Special hint for the reassembly: Push the connector inside until it is over the corresponding connector of the logic board. Then insert a thin tool over the connector and push it down onto the logic boards connector.

Trenne das Kabel zur Kopfhörerbuchse mit dem Spudger vom Logic Board ab. Du musst dazu den Stecker behutsam zur Vorderseite (bzw. nach oben, der Stecker funktioniert wie bei LEGO® Steinen) des iPods drücken, bis er sich vom Logic Board löst.

Ein spezieller Tipp für den Zusammenbau: schiebe den Stecker hinein, bis er sich über seinem Anschluss auf dem Logic Board befindet. Setze dann ein dünnes Werkzeug über den Stecker und drücke ihn nach unten in den Anschluss auf dem Logic Board hinein.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.